Prime Radiant

This is a very delicate print, designed for resin. The dxf file is for laser cuts, each side is 44.9mm and the edges only are bonded (I use WeldOn 3). See this video for a better idea of what it's about. https://www.youtube.com/watch?v=BQjSwPJL_rI

I left off the symbols on the sides, as I never really liked them.

The clear resin can be anything clear, but I use CrystalClear 204 from Smooth-On. Do not pour all at once, pour in 3-4 increments.

Note: for the last facet, make sure you pour the resin right up to the inner edge and let it cure; it will be slightly concave. Then, sand the acrylic down to that edge. Add a last small pour of resin, then cap it with another piece of acrylic, working any bubbles out. Let it cure a good long time before peeling away the acrylic facets.