45° extension stand for LaskoMEX MVC-8251 video intercom

A 3D printable 45-degree extension stand for a Lasko MEX MVC-8251 video intercom.

I got this thing installed as part of my building's electrical system renovation, but it was mounted quite low and parallel to the wall (and the viewing angle was so bad I had to bend over to see who was calling).
So I decided to make this extension stand to see it better.

It also has a small empty area in the middle (about 4.5 x 4.5 x 7 cm) for easier cable management (or in my case to put 2 ethernet keystones there for modular cables) and a small hole at the bottom of the base for the cables to exit.

Designed to sit right in between the wall and the original mounting plate that comes with the intercom (which usually just gets screed to the wall) - uses the same mounting hole spacing (6.4 cm), so you just need 2 more screws.

Full dimensions:
9.2195 cm
8.3 cm
7.3739 cm