Wera Tool-Check PLUS slide stopper

I noticed the universal bit holder on the top tends to slide out the end of the Wera tool check plus, causing concern I may lose it.

I remixed the original build from Revvexd and added an extension out the end with a stopper to prevent it from sliding out.
I found Michael did a great job with his build and it fit perfectly at 100%, so much appreciation to him. Please see his @ https://www.thingiverse.com/thing:4761249

The print is blank but my build had my employee number on the end

I have only printed in the orientation in the photo attached

I am always open to suggestions so please comment and make sure to post your build.
Thanks

EDIT
As per requested, the tear drop was removed and the stopper was reduced to a far simpler flat end.