Bullet Feeder Die 44 MAG/SPL

9/38/357 version: https://www.thingiverse.com/thing:6507175

Any and all feedback is appreciated!

Short and sweet for now. Should work similarly to my other designs.

Tube size .625 O.D. with I.D. that matches your bullet diameter (44 Magnum/Special = .429in). Bitspower 16mm O.D. tube should work and be cheap online.

Print both parts, clean small holes with 3/32 drill and center hole with 15/64 drill. Glue base insert "green part" in with the large angled edge facing out. MAKE SURE PINS SLIDE SMOOTHLY AND FREELY BEFORE GLUING!!! Pin size 3/32 diameter .75in long.

Recommend teflon tape instead of nut, but whatever works. All parts should thread finger tight.

Print big end down!