Summary

These feet / legs were designed to replace the broken rear feet on a Rohde & Schwarz CMS communications test set.

They are not identical to the origional part but are made to fit while looking similar.

They should fit all of the CMS 50 series as well as the CMS 33,36 etc.
(They may also fit other R&S equipment, but I have not tried)

The provided STL's files are handed for left and right sides. (They are the same part just mirrored)

Print Settings

Printer Brand:

Creality

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Ender-3 Max</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>30%</p></div></p>                                                    <strong>Filament:</strong> Sunlu PLA                Grey                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I printed them with the legs on the buildplate as I found this produced best result. </p><p>Supports should be set to everywhere. </p><p>The origional R&amp;S parts have inserts which the screws pass through to attach to the instrument. These form a small spacer to take up the gap between the feet and the instrument outer case. I did not recreate the spacers on the print as I reused the metal inserts from the R&amp;S parts heating them and pressing them into the print. To be honest they are not really needed and just the screws alone would be fine (Just don't overtighten the screws or they may break through the print). You could always print some small washers / spacers if you want. </p></div>

Post-Printing

            <p class="detail-caption"><strong>Left and right printed feet and the origional part (top)</strong></p>                <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/50/38/cc/ba/a3/0bd0626c-4ebe-4603-9d55-08f4c3a69fd9.jpg"></p>                <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/0d/83/9a/98/7a/6bdbdee6-ae23-4a54-b3be-e0ca042bd983.jpg"></p>                <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/17/d5/fc/69/30/fc69cb9e-deba-409d-a354-9be2670f1ed1.jpg"></p>                <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/33/2e/0a/4f/08/1dfe831b-522d-4f68-b867-6637c8dfbb56.jpg"></p>

Rohde & Schwarz CMS Rear feet / legs