Summary

3 sticks of dynamite with a 5/8" threaded hole in the base to suit a brass insert beer tab adapter.

Print Settings

Printer Brand:

Creality

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Ender-3 v2</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20%</p></div></p>                                                    <strong>Filament:</strong> Tianse PLA                Red                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I printed this with and without supports.  With supports left a crisper bottom edge on the bands, but without was barely noticable as well.<br>I printed this in the vertical orientation.</p><p>The 3 part wick is intended to be printed in 3 parts, using black PLA, then superglued in to the dynamite after.  This allows the wick to be printed in the flat position, resulting in a stronger print.</p></div>

Post-Printing

After printing the 3 piece wick will need to be super glued in to he top of the dynamite. You may need to drill the holes a bit larger if it doesn't fit immediately.

I also wrapped the bands in black tape to give the appearance of seperate material for them.

Dynamite Beer Tap