Summary

I drew some inspiration off my last print I uploaded. I thought it kind of looked like a revolver bullet chamber so I decided to change it up.

Requirements

A decent amount of pennies
A 3D Printer... duh..

Print Settings

Printer Brand:

ELEGOO

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>ELEGOO NEPTUNE 4 Plus</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>10%</p></div></p>                                                    <strong>Filament:</strong> Printer Recommended PLA                Any                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I used tree supports instead of normal, I found it made it easier to take out the support that goes right up the middle of the top half. It can be a bit tricky but as long as you have a pair of needle nose pliers you should be ok.</p></div>

Revolver Themed Dab Pen Holder

Requirements