Watchmaker screwdriver holder rack - Kwong Yuen GY0108

First proto for :

Rack for 10 pcs. of the Kwong Yuen watchmaker screwdrivers GY0108.
These 'better than average' screwdrivers are ~ 5...7 $ a piece.

I wanted to make it small so I could put a glass yarr over the whole thing.

My proto was printed in PLA+ with 0.6mm nozzle.
Printing with adaptive layer thickness will speed up the print.

In the bottom there is space for a 608 Ball bearing (22-8-7mm) if you want to make it into a carousell.

Points of improvement :

• The angle of the screwdrivers is low (7deg) so some don't lean against to top, but rest more on the butt-end. the bottom resting surface need adjusting so the screwdrivers 'falls' towards the middle.
• Hardly anybody will use all 10 sizes of the screwdrivers when servicing a watch, so a rack that holds say 6 pcs will be more practical.