Summary

This is folding a sun hoodie for a Yamaha DM3 audio mixers touch screen. Its held in place with 1/4' (6.3mm) neodymium magnets.

Print Settings

Printer Brand:

Bambulabs

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Bambu X1C</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                    <strong>Filament:</strong> eSun PLA+                Black                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Prints as one part in upright working position.<br>Little bit of support, plate only for the magnet holes.<br>Support threshold set to 4 in Bambu labs seem to work well, Wall loops set to 4 (so they are solid)</p></div>

Post-Printing

The hinges will stick together slightly. Best method Ive found to free them is to support one panel on a desk edge while using the whole palm of your hand to put even pressure on the panel you want to free until it snaps free.

The 1/4 x 1/4" cylindrical neodymium (rare earth) magnets are gently pressed into the print after carefully heating the print and the magnets slightly. Too much heat on the magnet will make them loose magnetism

Yamaha DM3 sun hood