Summary

The idiot that installed our Clack iron & sulfur filter set the discharge pipe as to run just in front of an around the injector housing cap, making it not possible to get Clack's spanner type wrench on the cap. So, using FreeCAD I designed a 1/2" drive style socket to fit the cap.

I have included both the .stl and .fcstd files.

Print Settings

Printer:

Anycubic PhotonMono M5

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.01mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>no</p></div></p>                                                    <strong>Filament:</strong> n/a Anycubic ABS-like +                n/a                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Use your known good settings. The last photo shows how I oriented and supported it. It should not require any scaling.</p></div>

Post-Printing

I post-printing cured it in a 15 mW/cm² 405 nm UV curing chamber for 2 minutes...

How I Designed This

Designed from measurements of the cap, using FreeCAD v0.22

Clack WS1 Injector Cap Tool