Fractal Design Spacer, Hinge, Brackets, Etc

FDT_Spacer_18mm
Required Screws: 5 x 6-32x1"
Note: The uploaded one is slightly different from the one I currently have printed. It includes a bar going from each side to stabilize the thin side better. It should not interfear with anything. I plan on printing it once I am able to print without getting any lifting on my printer bed since this takes nearly the entire Ender 3 bed.

FDT_Side_Panel_Hinge_With_Dowel_Pin
FDT_Side_Panel_Hinge_No_Dowel_Pin
Required Screws: Used Existing Screws
Optional Dowel Pins: 2x16mm
Notes: There are two variations. One has a hole to use the dowel pin from the existing hinges. It is difficult to remove the pin from the slider pin without damaging it. Due to the printing orientation the pins may not be required so I included a file without the pin hole. You can loosen the screw and slide the hinge to remove the side panel.

FDT-Top-Rail-Bracket_With_Dowel_Pin
FDT-Top-Rail-Bracket_No_Dowel_Pin
Required Screws: Use Existing Screw
Optional Dowel Pins: 2x16mm
Notes: This removes a large portion of the center of the top rail. I required this because the existing rail interfered with my GPU. The rails are held on with double sided tape but it is really not necessary. I have a version to take dowel pins as well but you will need to cut one short if you do not want to buy ones different from the hinges. I needed this due to the top warping out of place. Since using the one with the dowels I have not had warping.

FDT-SSD-Bracket
Required Screws: 2-4 x M3 Mounting Screws
Notes: Secure the SSD to the bracket with 2 to 4 screws then you can attach the bracket the clips which can attach to the front mount or clip to the bottom of the case.

FDT-SSD-Front-Mount
Required Screws: 2 x 6-32x1/4"
Notes: The whole purpose of this bracket is to allow mounting two SSDs to the front of the case. The existing design was very limited with one SSD and the access to the power and SATA was not great. This is slightly different from the one I have currently printed to remove a lot of plastic not needed. There are two sets of holes on this bracket which allows mounting on both sides and they are labeled. It is labeled for the left and right. You will need to print some SSD Mounting Clips in order to secure the SSD Bracket.

FDT-SSD-Mounting-Clips
Required Screws: 2-4 x 6-32x3/16"
Notes: These clips can snap on to the bottom of the case or on the Front SSD Mount so you can attach the SSD Bracket. Once a screw is added it forces the clip to be open and not fall off.