Summary

A slip on adaptor to allow an iPhone 8 to be connected to the eyepiece of an inspection microscope. I have used the 'generic' clips before, but found them to be difficult to setup and very sensitive to being bumped or slipping - or worse dropping the phone.

This design is intended to just slip on to the phone and be ready to use with your microscope right away.

Print Settings

Printer Brand:

Creality

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Ender 3</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>15%</p></div></p>                                                    <strong>Filament:</strong> Generic PLA                Black

Post-Printing

After printing the base and the lens adaptor, check placement and fit and epoxy lens adaptor to base before use.

iPhone8 to microscope adaptor