Morsbane for Heroscape, splitted

Made from lyte3d's "Morsbane" (https://www.thingiverse.com/thing:4653568) and a base I made. If you print on high resolution mode (ex: 0.1mm layer height for a 0.4mm nozzle) then you should be able to print it without any further supports, like I did, then glue everything together.

You may need to hit 'Separate Connected Surfaces', or else it might glitch up around the supported areas, though modern slicers may be able to handle these sections fine.

May also be very good as a druid or wizard for DnD