Halberd, Poleaxe Spear Head

This is meant to be combined with the halberd design I also created as an alternate to commercial products (https://www.thingiverse.com/thing:6484574). These spear heads were designed for use in the SCA cut and thrust polearm experiment (approved for use as of 2/13/2024).

-Print with TUP and Gyroid or Rectilinear infill at %10-%15 infill to make sure the blade flexes.
-These will fit on a 1.25" diameter round shaft with a taper on the end.
-After putting on halberd, put this head on top of the shaft and tightly tape down to the shaft first then fill any gap and tape all that to the halberd.