Summary

This is a pusher base for inserting Pixel Nodes into pixel strip. I used it specifically with Holiday Coro PixNode Extreme Strip. It should fit others, but has not been tested.

Was printed using PLA, .2mm layers and 45% infill. Could probably use less infill to save time and material.

I have included the .step file from Fusion360 so it can be easily edited to suit your needs.

Print Settings

Printer Brand:

FlashForge

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Adventurer 5M</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>45%</p></div></p>                                                    <strong>Filament:</strong> N/A PLA                N/A

Pixel Pusher Base For PixNode Extreme Strip