Goku Black (Zamasu DBS) Scythe

The .zip file will have all the pieces named after how they connect to one another (Ia - Ib was a bit of an improper cut on my end).

Layer height is 0.24mm, but can be put down to 0.2mm, though I doubt the difference would be massive. Since you're printing rather large parts, perhaps try to increase the layer height for an even faster print.

Make sure to orient the pieces to accommodate your printer, as it's scaled up to be 180cm tall, then cut into 15-20cm tall parts.

The blade parts will be heavy if you print with a higher infill density - so we need to maintain some strength with the least amount of weight possible, hence why I chose the 5% Adaptive cubic for it.

The shaft should be stronger so I chose 15% infill for it in hopes that it will stay strong enough to support the ~200-300g of plastic from the "blade" part.

To connect the pieces, I sanded each connecting part down a bit until the whole surface was flat and simply used a bit of super glue to connect them and they hold perfectly still.

Dowels/pins can be added, but you'd need to take the original, scale it, and cut it into pieces with those enabled. I used OrcaSlicer for everything here.