Ka100-X30-Rok VLR engine plugs

I made these to go over the carb, the manifold and the airbox for the Ka100 the X30 and Rok VLR. I printed in PETG on bambu labs A1 printer. I had the bed temp around 80c-85c and the hot end around 255c-265c you can mix and match setting for your printer but I found it prints best in this range. you can try printing in TPU but I don't have any at the moment and I have not printed TPU before. I made these on shapr3d. if you print in current orientation you don't need to use supports. infill wise I would not go below 30-40% and make sure to have at least 3 wall loops for strength because the plastic has to flex. please don't sell it but you can give it to people.