Fuel Pump Block-off plate, Ford V8 302, some Chevy

This is NOT for functional use. Engine heat would warp and melt any 3d printed part in this area.

This is for storing the motor, or cleaning, painting, etc. One is smaller and different shape than the ones you can buy, so there isn't a visible edge of paint when you put the real block-off plate or fuel pump back on.

Will include DXF in case you could laser cut a tougher heat resistant material or make your own gasket.

Ford Windsor, 302, 289, 351 etc and Big Block Chevys should use this same shape. Maybe some SBC, but you'd need to confirm. I just know for sure that it works on older 302.