OIS -> Starlock adapter for Makita DTM52

This is a 3D-printed OIS -> Starlock adapter for the Makita DTM52 oscillating tool. Additionally you need an M6x90 screw with a flat top which must be cut as shown on the attached pictures.

The adapter sits tight, there are no gaps, although I'm not sure how strong it is and how it will perform. Quite a short test (about 10 minutes) with a saw and a sand paper accessories passed perfectly. Since the adapter is quite small and very cheap, you can print a lot of them and easily replace one in case of a breakage.

I printed mine in PETG (0.4 nozzle, 0.2 mm layer height), but ABS should perform better. The adapter idea is not mine, I saw it somewhere on the Internet.