M365 Xiaomi additional battery case/holder 8000mah

Remixed from the 6000mah here: https://www.thingiverse.com/thing:3798199

6000mah has batteries per cell, mine has 4, so literally sliced the drawing in 2, added in 20mm to the container and lid, job done.

All other configs the same, so read that for instructions. I don't want to sell of their work as mine, as i literally spent 5 mins doing this... Took me longer to take photos.

I printed in ABS, but if i were to do again, i'd use PETG as its a little brittle. Time will tell. Great design tho! I also added in some zip strips too.

I used a 0.6mm nozzle at 0.3 quality. I actually used no supports but i did use a brim. Worked a treat.

Finally, a few notes:

As to the battery, i needed to snip some of the shrink wrapping off as it interfered with closing the lid. I also used gorilla tape to seal it in place. The only part of the original design that isn't perfect in my mind, however decent enough.

Additionally, you can't store the device fully closed into the hook.

I like this design as it allows my little one to put her feet under the battery. I previously used a material cover which was ok, but never truly held in place.