Summary

Rocket by JJBTEXAS remix

Instructions

[UPDATE] I just noticed that both the top and bottom parts will easily fit on the 5.5 x 5.5" Afinia buildplate. This print requires 2 hrs 30 minutes, 60 grams ABS.
And if both are printed together, there is no need for the "sacrificial bar" mentioned below.**

===
This rocket reminded me of some childhood thing... can't recall what... a cartoon.. or a toy.. so I printed one.

But it was slightly too tall for Afinia's build volume. Rather than scale it down, I cut it, and made a stash box.
The top fits good and snug.
The box might be worthy of a hinged top, if someone has the inclination to design it.

Bottom part took 1 hr 54 minutes, used 45grams ABS with Afinia defaults (0.3mm Z, medium speed with raft).
Top section, 39 minutes 15 grams.

Using the default Afinia "support angle" of 30 degrees there was no support to remove from inside the top (lid) or outside the bottom part (except on the very bottom of the rocket).

**To get a nice sharp point on the top lid, I used a sacrificial bar (STL included) to occupy the hot extruder between layers and prevent overheating the tip top. Place it near the model on the platform.
(Only required if the top is printed by itself.)

rocket remix