Toyota Highlander Broken Radio Knob Repair Part

This repair part is designed for a 2nd gen Highlander where one of the radio knobs has been broken.

This was made specifically for a 2012 Highlander Limited. This could work for other Toyota models, not sure.

I made this repair part that goes over the shaft of the knob to hold it in place. This is all friction fit, no glue required. Of course you could glue it if you want, but it is not required.

Notice the four holes for allowing the LEDs on the base to be visible. When installing, the shaft needs to be lined up so that the little tabs go in the correct spots at the base of the shaft, and the LED windows should be lined up so that the LEDs can be seen.

Ideally, print in clear so the light from the LEDs does not get obstructed.