Simple 1:64 Scale Wall Display for Hotwheels/Matchbox Cars

Hi Y'all!

This is an angled wall stand for 2 1:64 scale cars, which can be used to display your favorite showpieces!
It took me about 2 1/2 hours to print this with an ender 3 and a 20% infill, though i bet this would work fine with around 5% as well.

It may need to also be scaled to 1000% to print with proper dimensions.

As far as actually mounting it to the wall, it has two holes in the back that will fit a standard thumbtack. The thumbtacks can be glued into the holes with a hot glue gun, superglue, model cement... etc.
For the angle in the pictures, I used a 45º tilt for the stand, though the stand can theoretically be put at any angle >0º and <90º

Thank you for reading this and hopefully downloading the design!
-Icewing177