Red Team Tools UDT handle (2 versions)

A tough, utilitarian Under Door Tool handle for the Red Team Tools Under Door Tool. Two versions, one with a holder for r134a canisters (Not tested, please message me if there are improvements/ problems, I don't have the canisters) if you want to add them for REX sensor bypass, the other for just the bare tool, with a slot to store in the folded position. Enjoy!

Printing: You likely know more about printing than me, but I used PETG as I had a bunch laying around, I printed it without supports with the flat bottom edge to the print base (the internal slot is then vertical), and added the "fuzzy skin" texture in CURA to give it grip/ reduce the shiny PETG finish, this also allows you enjoy thicker layer heights without it looking worse.

It's a tight fit for the 3mm wire of the handle, sometimes a flat file can be used to clear any stringing inside the slot, and you may with to use a grinder/zipdisk to trim the end of the wire on the handle end so that both sides are parallel when they are in line, as mine came a little longer. Other than that, figure the rest out yourself, good luck!