Temple Audio Mini/Micro Module Plates

These are mounting plates for Temple Audio pedalboards which allow you to install "D Punched" style connectors into any slot. Works with Neutrik locking TRS connectors, XLR, USB, Midi and other accessories.

I also created blank plates if anyone wants to remix this.

It may be a good idea to print the longer plates at a high infill as it has the potential to be rather flimsy. Printing the reinforced plate at 20% infill yielded excellent results.

Update - 2/24/2025
I designed a reinforced version of the 3 hole Mini Plate and Micro Plate. They are double the thickness and include countersink holes for M2.5 hex nuts. The tolerance is pretty tight, so I found the best way to insert the nuts is to line them up and then squeeze them in with something flat, like a credit card.

I found that the two 2 mm thick screw tabs on each end are prone to failure and snap easily. I redesigned the tabs to be a lot thicker, thus requiring longer screws. To attach the plate to the pedal board, you cannot use the small M3 screws that came with the board as they are too short. You will need to use an M3 6mm long screw with a head diameter of about 5 mm. Be sure to print this with supports so the end tab screw holes turn out correct.

To attach accessories to the plate, the nuts and bolts I used can be found here: https://a.co/d/5kvkMYM

To attach the plate to the board, you can use the M3 6mm screws found here: https://a.co/d/eyg2EQw