Bosch FL12 / GLI 12V-330 Professional Lamp Case

I made this case for the Bosch GLI 12V-330 Lamp. At least in Brazil this lamp is called GLI 12V-330, but I've found the FL12 lamp and they look very similar, if not, the same. So if it doesn't work for the FL12 let me know please.

You can store 2x 12V batteries, 1x Lamp and there's a place where you can store wathever you'd like.
I put this "pin / shaft" on the lid to hold the lamp, in case the case turns upside down.

Notes:

1) Don't rotate any part, even the shafts, print as it is, in the horizontal, this way it stays stronger. I think if you print in vertical it will break easier when you press the clip lock.
2) You don't need any support.
3) Use brim for the clip lock.
4) The clip lock has a top and a bottom side. Check image below.
5) I put 3 sizes of shaft locks but I would start with the tight one. It worked great for me. If it stays too loose, use the tighter and too tight use the medium. Let me know if none of them works.
6) I used 0.2 mm layer height.
7) You can print the case and lid with 10-15% infill.
8) I think I printed the shafts with 15%. But if you want, you can print it with more infill so it says stronger. But you don't need more than 40%.