Summary

fits in the oled spot. two piece design snaps together to hold the touchpad very securely. put a rubber stopper / bumper between the mount and the plate at the top / farthest part from the screws to hold up the far end and keep it from wobbling.

Print Settings

Printer Brand:

Bambu Lab

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>A1</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.08</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>25% 3d honeycomb</p></div></p>                                                                                <p class="detail-setting filament_material"><strong>Filament Material: </strong>                     <div><p>PETG</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>the top piece is a nightmare to print because its one big overhang. ive printed this a dozen times in every configuration you can think of and the only way I could get it to come out flawless was to print it in the flat/standard position (so you get a nice clean top surface, otherwise the top surface is where the supports sit and it looks ugly)and I had to use PLA (I print PETG) for my support interface. with pla support interfaces and a bit of XY distance I was able to get the supports to come off clean</p></div>

Post-Printing

cirque 40mm touchpad mount for boardsource unicorne / crkbd corne keyboard