Multimeter Probe Casing

My multimeter probe was a bit battered and cracking so I decided to replace it .
I knocked this up in a few minutes to do the job.
Quick tip, slide a piece of heat shrink tube onto the wire first then when probe pieces are in place slide the tube over the probe and heat to hold it all together.
Designed simple and quick and prints quick.
Hope it's useful to others too.
Made to fit the multimeter type shown in photo.
Feel free to improve on it if you like.
Print in Black or Red as needed.Tip: Fist put a red heat shrink tube on the wire then after putting the wire in the parts slide the tube onto them and then shrink it.
Please also see a case with slide in lid at https://www.thingiverse.com/thing:6947293