Guards of Atlantis 2 Insert (2nd Printing only)

More information here:
https://boardgamegeek.com/thread/3458083/storage-solution-wip-core-box-only-1-2cm-lift-3d-p

Please note:
0) I am providing these files for free but I am not providing free support. I wrote some notes below, but please figure this out on your own.
1) You'll need magnets and flashing to store the miniatures. See the link above for more information.
2) You need thin Mayday sleeves. It will not store unsleeved cards (well) or premium sleeves (at all). Again see the link above for more information.
3) You will have 18mm of lift and love it because it is all still stored in a single slim box.
4) Vertical storage is supported.
5) It has all the content from the Gamefound campaign.
6) Read the BGG post for more information. That is the link above.

What do you need to print?

You have options as there are more files than what you need.
The 88mm boxes as for every hero without a token not named Takahide
The 108mm boxes are for every hero with tokens not named Gydeon; use the appropriate TokenSupport to store token with the cards
The boxes for Takahide and Gydeon are labeled as such.
The 136mm box is to store your hero profile cards if you want to keep those separate. I would recommend measuring the other boxes if you do that and make them a little slimmer. Otherwise you will need to magnetize and store this box along with the figures.
For the minions, you can go with either minionsBox or MinionsBox_Shortened + ClipsBox. I made some clips to track the level of my characters and tokens for the items that box can store them.
For the coins, you can print one coinsbox or two coinduo boxes. The latter allow you to split up the coins and put one on each side of the table.
Supporter.stl is a bit that you can slide next to the miniature boxes to create a little support for the player boards.
Everything else should be straightforward.

I recommend grabbing some calipers and measuring the cards in sleeves and updating the box widths to suit your needs.