Mini Legion Robot

This is a mini model (1:4 ratio) of the plastic antweight, Legion.

Build instructions:
Print the Side Armors, servo, drum, and arm in blue. You may have to re-orient them in your slicer.
The side armor pieces are made to be printed flat side down. You will need supports for side armor and drum

Print the drum on its side

Print the main body (the frame) in white or blue

Assembly instructions:

Press fit the servo in the pocket on top of the main body. If it doesn't fit, use a hobby knife or superglue
It should fit about 2/3 in, with 1/3 sticking out. The nub should be pointed away from the center of the body. See pictures for reference

Add a drop of superglue on the wheels to attach them to the frame. Let dry
*note: the side armor pieces look very similar:
you can tell them apart by the slight angle in the front armor. see pictures

Superglue the flipper arm to go from the servo nub to the top of the frame's ear

Use 2 M2 screws (anywhere between 6-10mm) to hold the drum in place.
If you want it to spin freely, drill a hole slightly larger than 2mm diameter through the drum