Stern Godzilla Pro Pinball Bridge Mod

I made a remix of a toy-train bridge to fit my Godzilla Pro pinball machine (the pro just doesn't look right without a bridge above the magna-grab). A few tips: 1. You will need to file the edges of the tabs at the top of the side-truss' to snap into the top-truss (nail file works - the 6 tabs are a little too wide - glue is not required if you file down the tabs just-right). 2. I attached the bridge using zip-ties from the bridge-bottom to the metal cross-member just before and just after the bridge (see top-view picture). 3. Although the model has small screw-holes, you will need to drill the holes prior to assembly (holes are small - you will crack the plastic if you don't drill). I used #4 x 3/8" screws to attached the sides. [Note: I added a "v2" version. The v2 is about 10mm longer and about 8mm thinner - it fits the space a little better than the original. The pictures of the gold bridge are the original, the clear bridge is "v2". Both work great, but I think I prefer the "v2" look over the original. Also note - I printed this on a 6 year old sub-$200 printer, excuse my terrible surface finish.] Thank you to the person how made the original model - I just scaled it and made some small mods to fit the machine.