Micro Talon Aileron spar tool

My LW PLA hole would warp somewhat so I had to hammer my spars through. The tool allows you to hammer the spar into the negative and leave the same 10mm and 12.5mm spar spacing on either side of ailerons
Tail tool has ~2.4mm hole sunk 12.5mm so the 120mm spar passes through the 95mm aileron, leaving 12.5mm on either side of aileron for fitting

Tail negative has ~2.4mm hole sunk 12.5mm so the 120mm spar passes through 95mm aileron flush with tool

Wing tool has ~2.4mm hole sunk 10mm so the 200mm spar passes through the 180mm aileron, leaving 10mm on either side of aileron for fitting

Tail negative has ~2.4mm hole sunk 10mm so the 200mm spar passes through 180mm aileron flush with tool