Silent Haptic Fidget Coins!

NOTE:
All Female Dimensions are + .25mm and Male dimensions are +- 0mm
Each Type has a .6mm Gap between the faces when built!
I VERY HIGHLY recommend printing on glass bed for the sleek, grippy finish on the top.
Infill doesn't matter, I just did 100%.
Print with No support orientation as in picture.

REQUIRED ITEMS
9 to 12 6mm Wide x 2.65mm Deep magnets Link I know it say 6x3 but these work.

10mm ID x 15mm OD x 4mm Tall Bearings Link

Things you may need
Soft Jaw Clamps/Vice grips (to press in magnets) Link You shouldn't need these but it is an option.
Superglue/Glue, needed in case your magnets are not press fit. Also used for bearings.

File Descriptions
Haptic Triangle Flat Edges:
Mimics the INDX Haptic Coin, a little larger than its dimensions for a bit of extra heft, uses 9 magnets total and 1 bearing.

Haptic Triangle Rounded Edges:
Also mimics the INDX Haptic Coin, except more rounded, same dimensions as the flat edge variant, more of a preference choice here. 9 magnets, 1 bearing.

Haptic Coin:
Mimics the "Milk cap" format for haptic coins, multiple variants listed below.
6 Magnet - most clicks and most closely feels like other "Milk Cap" haptic coins, every 60 degrees.
3 Magnet - 120 degree spacing for a slightly longer time between each "click"
2 Magnet - 180 degree spacing for someone who prefers a smoother style of play.
1 Magnet - For someone who like the feel of turning a bearing or spinner with a satisfying end to each rotation.