Poise Tool for Balancing Shafts

This print will convert a standard movement holder to a poise tool. The video below is how to build the tools step by step

https://www.youtube.com/watch?v=baj90rYcM7A

You will need:

Make the print 2 times.

1 Standard movement holder (horizontal rods are 25mm apart (on center) to confirm size before starting)
2 Razor blades
6 Heat set (3mm thread size)
2 for holding the razor blades
4 for the leveling bolts
1 Ball point pen spring (cut into 2 halves)

Print details: (I used but, not needed for your success)
Material: PLA
Layer height: .38
Supports: Yes
Bed Plate adhesion: Brim
Infill: 25%

Thank you,
Le Jeffe