Fujifilm Disposable Lens light seal.

I printed the lens body way ahead of ever finishing the roll of film that came in the camera. So to my surprise I find out the fujifilm disposable lens doesn't fit the hole like the original does. If you too already bought a fujifilm for this project don't worry it can still work. If you trim the plastic from the inner body around the lens down to pretty much just the lens you can still push it through the hole in the lens body but the clips that hold it in place have gaps in them that leak light. That's what this print is for, I press fit the ring into the hole at the very edge of the opening. Then superglued the back of it to the lens body. After that I put glue on the sides of the clips of the lens hold and then carefully clipped that in. After letting that dry I added some additional glue to the outside to make sure everything was locked into place. This method still works 100% there's no cropping or obvious distortion in the images so no need to return your disposable. That being said this file is just a plastic o ring but hope it saves you like 10min.