Comma 3x Ford F150 Rear view mirror Mount

Mount for Ford F150 rear view mirror integrated 8 degrees. Might fit other models. I designed it based on a 2021 F150. You should print in ASA. I used Craftcloud to print with 100% infill and they did a fantastic job, turned out great. A little expensive but worth it. I didn't print with ASA at home because I don't have the proper ventilation. It is a tight fit but that's what you want. I believe I used a 6M screw at 3/4 inch length with a couple of lock washers on it so that it pulls the mirror up tight with the mount. I put a piece of sticky back felt on the back of it and cut around it so it has a soft backing and is not scratching on the windshield.

Look to the original for parts to order that need to be glued in. I would Suggest getting the fastest transfer rate you can 40 GBs or better for the hardware.

I would also put your hardware components together where everything fits right and then apply the Epoxy at that point so everything fits properly once it's dried. That's the trickiest part of this whole thing..
The Comma 3x mount is from original designer.