Honda nc700x indicator mounting part

I designed this part to mount the stock indicators on my Honda NC700X. When I bought the bike, the indicators had been replaced with aftermarket LEDs, and the original brackets had been thrown away.

To mount the bracket, you’ll need one M6 bolt and nut.

The seal goes on the outside. When mounting the indicator, press down on the seal to ensure a secure fit. If your printer can’t print TPU, I found that the bracket still works fine without it—just make sure to press down on the indicator while tightening the screw.

As for materials, I used PLA with 100% infill. The layer height was set to 0.2 mm. The same settings apply to the seal, except I used TPU instead of PLA. The specific grade of TPU doesn’t really matter.