Lucky Pig Paw preferred over ragged rabbits foot

Short answer:

A rabbits foot is fine, but the ancient orient knew pigs are symbols of wealth, prosperity, and bravery.
SO swap out that old ragged rabbits foot for a Lucky Plucky Pig Paw of Prosperity.

You might want to print a few extra.. just in case someone pilfers and pickles your pig paw.

Medium answer:

Two builds and a part:

1. Print a Lucky Pig Paw charm with a loop for a key-ring or hook
2. Print a pair of Big Pig Paws for your pegleg pigs.
3. Print South Paw Pig Paw
4. Grab Pig Toes to include in your own designs
   NOTE: PigToes.STL does not have a flat bottom. Do NOT print

Long answer:

• All models were printed in white with no support or brims, and painted with pink spray paint.
  .
• LuckyPigPaw.stl defaults to a 1 inch (3 cm) long paw.
  I printed it with 0.1 mm layers, with no infill, brims, or support.
  When doubling its size, I went to 0.2 mm layers, with 20% infill.
  .
• BigPigPaw.stl defaults to 5 inches (125 mm) long.
  I printed it with 0.3 mm layers with 10% infill.
  I rounded the bottom edges with a file before painting.
  .
• BigPigHand.stl defaults to 4 inches (70 mm) tall.
  I printed it with 0.3 mm layers with brim, but no infill or support.
  .
• PigToes,stl defaults to 2 inches (6cm) long
  It was included so folks could add a pig paw to their own designs.
  This has a rounded and uneven bottom. DO NOT PRINT
  IF you want to print it THEN drop it .3 mm below the bed.