Summary

The antenna for my raspberry pi was not getting very good signal, so I created this mount for a higher gain antenna that can plug into the grill on the bottom of my printer. I included the blend file in case you need to adjust the diameter of the holes for your antenna.

Print Settings

Printer Brand:

VoronDesign

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Voron2 350</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2 Nozzel</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>40%</p></div></p>                                                    <strong>Filament:</strong> Overture PETG                Red                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I don't see this as a "high stress" part, so PLA would probably work just as well.  </p></div>

Voron 2.4 Antenna Mount