TPU Jaws for Doyle 5" Multipurpose Vise

Drew this up in Fusion 360. Fits the Doyle 5" multi purpose vise from harbor freight.

Magnets actually measure just short of 5mm X 20mm X 2 MM, The magnet pockets are extra deep to accommodate Hot glue, I figured CA glue would not hold with the flex.

I started out making actual jaws to swap out with the steel jaws, Then realized I'm too lazy to swap the jaws out. So I went for slip on jaw covers.

I printed in Overture HS-TPU which is 95A hardness, used 5 walls, 5 top and bottom layers, 80% Infill.