Adjustable lightsaber wall mounts

I had the idea that I wanted to put a couple of lightsabers on the wall, but hung diagonally as seen in the picture. The hooks I designed plug into the base plate and rotate to whichever angle you want. Could be used for vertical, horizontal, or diagonal. The hooks are held to the plate just with friction so I wouldn't try anything heavier than a toy lightsaber.
Comes with 5 STLS, you can combine them into one print job if you're confident in your printer:
-BaseShort-20mmHole.stl - single baseplate
-BaseTall20mm.stl - same shaped plate but extra thick, so you can mount one saber in front of the other, if crossed
-HookLowerLeft20mm.stl - The lower hooks have plates built in to hold the saber in place, this one would be if the bottom of the saber is on the left
-HookLowerRight20mm.stl - same as above, mirror image for when bottom of saber is on the right
-HookUpper-20mm.stl - All upper hooks are identical and will work with either baseplate

I used a CR-10 v3, 15% infill, supports for hooks, but not baseplates. Also, I could not get the upper hooks to complete without using a brim, which worked perfectly.

Note: I used Command Strips for mounting, so there are no holes for screws in the baseplates.