2417 CNC Router controller box (original design from radhoo)

I've downloaded and printed the control board for 2417 but it does not fit correctly and i didn't wanted to use threaded inserts SOOOOOO.
i made this version which has all you need.

1. Reinforced lid brackets and board holes, just screw a short 10mm screw about 3.5/4 mm diameter for the lid and a shorter like 6mm for the board, will never came off till you nuke it down to ashes.
2. Repositioned button lid hole, mine i dont know why was like 10 mm below the original, maybe my board version is different.
3. 40mm fan grill and holes, ready to cool the hell out of this (even if this board does not heat much, but i live in Italy 40 degree inside the lab are quite common.
4. If you haven't 6 cm long nails to reach the board on/off switch, well use the included button.
5. PLA any settings will be good enough, does not need crazy infill or infinite loops of walls.
6. improved "easy to fit" from side, just slide your board in from the side and you are good to go.
7. The box is 45mm, 10mm higher than the original, just to help you better insert the board and avoid any contact with the board and the possible fan.

May the print be with you.