Picknicktafel met luifel voor vogels

In aanvulling op mijn vorig ontwerp heb ik als extra tip ook nog een luifel aan het ontwerp toegevoegd. Daartoe moest de achterkant wel iets aangepast en is ter ondersteuning ook een kleine aanvulling op het tafelblad aangebracht. Er kunnen immers ook grote en zware vogels op gaan zitten of staan. Dus is een stevige constructie belangrijk. En toch GEEN schroeven en/of lijm nodig!
De luifel bestaat uit 9 geschakelde delen, die over een rails van de aangepaste achterwand kunnen worden geschoven tot er één geheel ontstaat. Elke lamel kan daardoor eenvoudig in een eigen kleur worden geprint. Aan de zijkanten zijn kleine vierkante gaatjes gemaakt, waar de vierkante stiftjes in passen. Daarmee wordt een stevige onderlinge koppeling tot stand gebracht. Lijmen is dan feitelijk niet noodzakelijk.
Voor de hoeken zijn een linker en rechter lamel (luifeldeel) met wat extra aanpassingen. Die hebben b.v. links en rechts slechts 1 vierkant gaatje ter koppeling met de overige. Ook hebben deze aan de achterzijde (die over de rails schuift) een klein gaatje. Deze correspondeert met 2 kleine gaatjes op de hoeken in de achterwand waar de rails loopt. Dit is voor de borging van de eindlamellen. Als je daar een kleine houten tandenstokertje door en door insteekt, wordt voorkomen, dat de lamellen van de rails kunnen glijden en blijft alles mooi bij elkaar. Daardoor is ook hier geen lijm noodzakelijk. Op elke hoekpunt is tevens plaats voor een ondersteunende paal. Deze wordt ook hier gefixeerd in de hoeken van de overhellende luifel als ook op het tafelblad met de vierkante stiftjes.

In addition to my previous design, I also added an awning to the design as an extra tip. To this end, the back had to be adjusted slightly and a small addition to the table top was also added to support it. After all, large and heavy birds can also sit or stand on it. So a sturdy construction is important. And yet NO screws and/or glue needed!
The awning consists of 9 connected parts, which can be slid over a rail of the modified rear wall until one unit is formed. Each slat can therefore easily be printed in its own colour. Small square holes have been made on the sides, where the square pins fit. This creates a solid mutual linkage. Gluing is then actually not necessary.
For the corners are a left and right slat (awning part) with some extra adjustments. For example, they have only 1 square hole on the left and right to connect to the others. They also have a small hole at the back (which slides over the rails). This corresponds to 2 small holes on the corners in the back wall where the rails run. This is for securing the end slats. If you insert a small wooden toothpick through and through, the slats can slide off the rails and everything stays together nicely. As a result, no glue is necessary here either. There is also room for a supporting pole at each corner. This is also fixed in the corners of the tilting canopy as well as on the table top with the square spindles.