Reloading

Made for my 460 Rowland but works for anything 45. Wanted more compact tools since I'm not loading in bulk.

All printed in PETG, .16 quality 100% infill with 6 walls. Can do less infill, but the 6 walls is sufficient. I just don't bother changing settings. No support on any except for the RCBS Hand Primer BOTTOM. You can run supports on the Lee Die Combo Wrench if your printer isn't dialed in and will print oblong holes or you can drill them out. You won't need to if your printer is setup properly though.

Lee Die Combo Wrench - Fits locking nut (knurled and hex), powder expander, and depth adjusting screw with two tension pins to apply pressure.

Small 45 ACP Funnel without grip tang (case mouth nestles into lip of funnel)

Small 45 ACP Funnel with grip tang (case mouth nestles into lip of funnel)

RCBS Hand Primer Top and RCBS Hand Primer Bottom - Made to hold 10 primers, but can hold 15 Large Pistol Primers. Got tired of the 200 ct primer tray that comes with it when I only needed to load 10 for test loads. Lid snaps shut for easy fill. PRINT BOTTOM WITH SUPPORT! The part that inserts into the hand primers adapter will need the support because it's .9 off the print bed. I've printed without support and it still works fine, but depends on your printer. I didn't make the rest of the bottom plate level with this because then the bottom of the tray would only be .9mm thick.

45 Loading Tray 20 - Holds 20 rounds. I use it to hold 10 cases and 10 bullets while I develop 2 different loads. I place 5 cases on top and bottom and the bullets in the center. Then charge the cases so I don't mix them up.