Height Gauge - Holder for X-Acto and Needle

I remixed the holder of the Height Gauge & Marker for pencils by MeisterEdel to use with a needle for marking metals and hard materials and made another for an X-Acto blade.
Because they're not as thick as the pencil, I was able to reduce the size of the holder.
The distance I achieved from the needle to the base of the gauge is 2mm, and from the base to the blade 3mm.

The needle is a 1.2mm diameter sewing needle and fit snugly into the hole. There was no need to glue it.
I cut it to 30mm from the tip.
The blade is a No. 11.

The fit tolerances are 0.2mm, which is typical for my printer.
However, some sanding or adjustments may be necessary.
But I only needed to use a tap on the original holder thread because it was tight.

!Be careful!
Both the needle and the blade are very sharp and dangerous.
Handle with extreme caution.

The other parts are original MeisterEdel designs.

Enjoy