Kobra 3 Max Shutter Case

I designed this case for my Kobra 3 Max to do stop motion animations with. It fits on the right side of your printer. I have linked the shutter remotes and included the G-code necessary for this model. The remote will fit loosely, so just in case your printer goes too far right, the print head will push out the trigger and remote and not damage either. I use Stop Motion Studio and Stop Motion Factory on iOS

https://tinyurl.com/27hf8wvf
The remotes that I use. I buy them in bulk so i don't have to worry about batteries, and I have them for multiple printers.

Gcode - add this to before layer change delete and paste

; BEFORE_LAYER_CHANGE [layer_num] @ [layer_z]mm
G90 ; Absolute positioning
G1 X420 Y210 F6000 ; Move to far right center (safe limit)
G4 P50 ; Pause 50ms
G91 ; Relative positioning
G1 X-30 Y-30 F6000 ; Approximate move back
G90 ; Back to absolute

SLOW DOWN TRAVEL SPEED Y by 50mm/s so the trigger has enough contact to take the photo without the print head in the way,

printed on Kobra 3 Max
.20 layer height
normal speed
outer-inner wall first
Polymaker PLA