Dillon XL650 Small Rifle Casefeed Plate

Remixed from clintmr20 large rifle feed plate found here: https://www.thingiverse.com/thing:6873632

This is a single file; print 4 of them and bolt together with M3 x 20 screws.

I printed with 8 perimeters and 20% infil for strength, which is probably a bit overkill. I also used supports on the buildplate as the internal corner, where the clutch fits, is an overhang.

I added a V2 of this design with a 4mm shallower slot for the cases as I found that two .223 cases were just able to sit in the same slot once the gap between the plate and the wall of the hopper was taken into consideration.