Toyota Key Enclosure

this is an enclosure for a key from a Toyota altezza key.
I have made this model to require four M2 x 4 Heated inserts on the front piece (side with logo). Im using four M2 x 6 cap screws that go through he back piece to hold everything together.
Found using support for the holes at the back piece is all good as you can just poke them out after. I removed support for the logo embossing - no issues with doing that bridging the gap will be fine, just means less clean up.
Also added some small foam pieces on the top and bottom inside faces where the actual transmitter sits as it is a bit of a loose fit.