Coke Bottle to 3/4" BSP thread connector

Print with the 3/4" thread on the plate, with the coke bottle end at the top.
no supports or raft needed.

Print Settings
Printer:
Anet A8

Rafts:
No
Supports:
No
Resolution:
0.15mm

Infill:
30%

Filament brand:
generic

Filament material:
PETG

Notes:
Just needed to use a generic 2L fizzy pop bottle, to connect to some 15mm copper pipe work. So using a PCO 1881 thread on the bottle side, and a 3/4" BSP thread on the pipe side.

also needs a couple of small rubber/silicone washer inserted in each end to seal properly.