Button Pin Pusher for ESP8266 NodeMCU V2 Case ( CH340G)

Simple Button Pin Pushing attachment for the following NodeMCU Enclosure.
Source Model: https://www.thingiverse.com/thing:4875061

My NodeMCU Dimensions:
58 x 31 approx

Note:
While removing the print from the plate, carefully put the tip of your fingers on the two budging points and pull sidewards. I advise pushing sidewards instead of the more natural squeezing inwards motion because that may bend the only 2 layer thick base of the part.

Print according to layer height, however it is recommended to print using 0.16mm. If you want to print the case with it too on a single plate, use different layer height for case to save time.